Under EPA's regulations, which of the following methods can be used to pressurize an R11 or R123 system for the purpose of opening the system for a non-major repair?
A. Adding nitrogen
B. Warming the refrigerant
C. Adding compressed air
D. Adding carbon dioxide
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Under EPA's regulations, which of the following methods can be used to pressurize an R11 or R123 system for the purpose of opening the ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Select the most economical W section of 50ksi steel for a 40 ft simple beam that supports a service concentrated load PL=30k at the midspan is laterally unbraced except at its ends and center line.
Answers (1)
If the outside diameter of a pipe is 2 m, the length of a piece of insulation wrapped around it would be a) - 628 cm b) - 12.56 m. c) - 12.56 cm d) - 62.8 m
Answers (1)
Specific cutting energy increases with increasing the cutting speed. a) True b) False
Answers (1)
An old refrigerator consumes 187 W of power. Assuming that the refrigerator operates for 17 hours everyday, what is the annual operating cost of the refrigerator, if the cost of electricity is $0.06 per kWh?
Answers (2)
Brittle failure is a type of failure in which: (a) There is large amount of plastic deformation (b) Large amount of elastic deformation (c) Very little plastic and elastic deformation (d) None of the above
Answers (1)
New Questions in Engineering
Roentgens are used to measure the amount of: uranium fuel burned radiation hydrogen isotopes
Answers (1)
What is the maximum % carbon for structural steel?
Answers (1)
An airplane flies from San Francisco to Washington DC at an air speed of 800 km/hr. Assume Washington is due east of San Francisco at a distance of 6000 km.
Answers (1)
An example of Ferrous alloy is Brass a) - True b) - False
Answers (1)
There is no difference in boring and drilling. a) - True b) - False
Answers (1)