The resultant of two forces p and q is 260N. if q is 80N and the angle between p and q is 30° find q

A gas pressure difference is applied to the legs of a U-tube manometer filled with a liquid with specific gravity of 1.7. The manometer reading is 320 mm. What is the pressure difference

What impact does modulus elasticity have on the structural behavior of a mechanical design?

What happens when you turn a jack

Carbon resistors often come as a brown cylinder with colored bands. These colored bands can be read to determine the manufacturer's target resistance value. The first two bands (L and M) represent the number.

What happens to the total mass of the reactants in a chemical reaction

Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.

The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius

Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.

What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution

The controller can be considered the brain of closed loop system