In a steam power plant, energy is added by heat transfer at a rate of 2100 kW at 680◦C at the boiler, removed at a rate of 1240 kW at 35◦C at the condenser, and the pump power is 75 kW. Determine: a. thermal efficiency of power plant b. maximum possible turbine power [kW] (assume same energy transfers at boiler and pump)
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “In a steam power plant, energy is added by heat transfer at a rate of 2100 kW at 680◦C at the boiler, removed at a rate of 1240 kW at 35◦C ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
The SDS for any chemical used at a job site must be available A. At the job site B. Online line C. At the contractor house D. At the nearest hospital
Answers (2)
A sewer pipe 8 inches in diameter can carry 0.662 ft3/s when flowing at a depth of 4 inches. a.) What flow rate can the pipe carry when flowing full? b.) What would be the velocity when flowing at a depth of 4 inches?
Answers (1)
Astronauts who landed on the moon during the Apollo 15, 16, and 17 missions brought back a large collection of rocks to the earth. The rocks weighed 154 lb when they were on the moon. The acceleration due to gravity on the moon is 5.30 ft/s2.
Answers (1)
When analyzing data sets, such as data for human heights or for human weights, a common step is to adjust the data. This can be done by normalizing to values between 0 and 1, or throwing away outliers.
Answers (1)
If angle A is a complement of angle B, angle B and angle C are vertical angles, and the supplement of C has a measure of 140°. Find the measure of A.
Answers (1)
New Questions in Engineering
16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.
Answers (1)
The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder
Answers (1)
What factors are likely to promote the formation of stress corrosion cracks?
Answers (1)
Find the mass if the force is 18 N and the acceleration is 2 m/s2
Answers (2)
Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion
Answers (1)