Ask Question
EngineeringEngineering
16 August, 06:29

What are two advantages of forging when compared to machining a part from a billet?

+4
Answers (1)
  1. 16 August, 09:28
    0
    Less material waste and time.

    Explanation:

    Two advantages of forging vs machining would be that with forging there is much less waste of material. With machining you remove a large amount of material turning into not so valuable chips.

    There is also a time factor, as machining can be very time intensive. This depends on the speed of the machining, newer machines tend to be very fast, and forging requires a lengthy heating, but for large parts the machining can be excessively long.
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “What are two advantages of forging when compared to machining a part from a billet? ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
is sampled at a rate of to produce the sampled vector and then quantized. Assume, as usual, the minimum voltage of the dynamic range is represented by all zeros and the maximum value with all ones.
Answers (1)
Calculate the drift current density (current density due to conductivity) induced in a silicon semiconductor at T = 300 K when the electron concentration is 1016 cm-3 and applied electric field is 30 V/cm.]
Answers (1)
Which one of the following statements about the Wright brothers is not true? A. They felt they had to get into the air themselves to further test their wing-warping technique. B. On December 17, 1903, the Flyer flew for two minutes and 1200 feet. C.
Answers (1)
What is the purpose of the following algorithm? input somenum Repeat the following steps for 14 times input variable1 if variable1 < somenum then somenum = variable1 print somenum
Answers (1)
The term PEL refers to a worker's Personal energy level O maximum exposure limit O the amount of lead in the blood stream O product efficiency level
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
Home » Engineering » What are two advantages of forging when compared to machining a part from a billet?
Sign Up Forgot Password?