Electrical engineering do

Define the stress and strength? A material has yield strength 100 kpsi. A cantilever beam has length 10 in and a load of 100 Lbf is applied at the free end. The beam cross section is rectangular 2""x5'.

What should you lubricate the grommets with when installing a new master cylinder reservoir?

Most car owners drive their cars an average of 12,000 miles a year assuming a 20 miles a gallon gas consumption rate determine the amount of fuel consumed by 150 million car owners daily

Talc and graphite are two of the lowest minerals on the hardness scale. They are also described by terms like greasy or soapy. Both have a crystal structure characterized by sheet-structures at the atomic level, yet they don't behave like micas.

Which of the following components of a PID controlled accumulates the error over time and responds to system error after the error has been accumulated? a) - Proportional b) - Derivative c) - Integral d) - ON/OFF.

What is the definition of a fluid?

You are ordering steel cable for a 250 foot long zip-line you are building in your back yard. The cable can be ordered in diameters with 1/16 inch increments. (1/16, 1/8, 3/16, 1/4, 5/16, 3/8, etc.

Which of the following statements is LEAST-Likely true? A) Do not attempt to unseat the beads of an inflated tire. B) Do not strike the tire or rim with a hammer. C) A hammer is sometimes necessary when removing a passenger car tire.

What is the pitch circle diameter of a 50-tooth spur gear having a circular pitch of 0.375 inch

Emergency plans are being formulated so that rapid action can be taken in the event of an equipment failure. It is predicted that if a particular pipeline were to rupture, it would release ammonia at a rate of 100 lb/s.