According to National Council on Radiation Protection and Measurements (NCRP) regulations, leakage radiation from the x-ray tube at 1 meter must not exceed
a. 10 Gya/h.
b. 10 mGya/min
c. 100 mGya/min
d. 1 mGya/h.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “According to National Council on Radiation Protection and Measurements (NCRP) regulations, leakage radiation from the x-ray tube at 1 meter ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
g 2000 m3/d flow from a dairy industry is treated in an activated sludge plant. The BOD5 is 300 mg/L, and most of it is in soluble form.
Answers (1)
Calculate how large a mass would be necessary to obtain a mechanical noise limit of [Equation] = 1 nG, 1 µG, and 1 mG if the mechanical resonance frequency is [Equation] = 100 Hz.
Answers (1)
Many radios can be operated either by plugging them into the wall or by using batteries. How can a radio use either source of current?
Answers (1)
Which of the following drivers has the right-of-way? A. a driver planning to turn left at a two-way STOP B. a driver seeking to turn off of a road that has dead-ended C. the driver who arrives first at an intersection with a four-way STOP D.
Answers (1)
Two routes connect an origin-destination pair with performance functions t1 = 6 + 4x1 and t2 = 2 + 0.5x2 2 (with t's in minutes and x's in thousands of vehicles per hour).
Answers (1)
New Questions in Engineering
5) A 80-kg man has a total foot imprint area of 480 cm2. Determine the pressure this man exerts on the ground if (a) he stands on both feet and (b) he stands on one foot.
Answers (1)
A car with an initial speed of 50 km/h accelerates at 5000 km/h2 along a straight road. a. How long will it take to reach a speed of 120 km/h?
Answers (1)
If high beam headlights are used improperly, it could cause glare for an oncoming driver or reduce their visibility greatly, increasing the possibility of a collision. a) b) True False
Answers (1)
The value of the critical Reynolds number for the flow over a flat plate is 5 x10^5. The significance of the value is: (a) The boundary layer will be turbulent where the Reynolds number is less than this value.
Answers (1)
The specifications of an electronic device are 24 / - 0.4 Amps. When the device exceeds specifications the average quality cost is $32.00. A sample of the devices had an average value of 23.9 Amps and a standard deviation of 0.211 Amps.
Answers (1)