Ask Question
EngineeringEngineering
17 April, 23:03

A force 25 N makes an angle of 30,45 and 75 degree with x, y and z axis. What should be the corresponding force vector?

+2
Answers (1)
  1. 18 April, 02:45
    0
    F = (21.651N, 17.678N, 6.470N)

    Explanation:

    The components of a vector in R ^ 3 are given according to their cosine directors, therefore, if we name F the force of 25N and Fx, Fy and Fz the components of the force with respect to the X, Y and Z axes, respectively:

    Fx = FCos30 = 25 (0.866) = 21.651

    Fy = FCos45 = 25 (0.707) = 17.678

    Fz = FCos75 = 25 (0.259) = 6.470

    F = (21.651N, 17.678N, 6.470N)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “A force 25 N makes an angle of 30,45 and 75 degree with x, y and z axis. What should be the corresponding force vector? ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
A fluid of density 1400 kg/m^3 and viscosity of 0.9 kg/m. s flows through an 80 mm diameter pipe with a velocity of 5 m/s. What type of flow exists in the pipe? Justify your answer.
Answers (1)
5. In the decision-making cycle, to Execute means to
Answers (2)
The stress is in the part working with static load. A. Dynamic stress B. Static stress or dynamic stre C. Static stress
Answers (1)
11. Three engines operate between reservoirs separated in temperature by 300 K. The reservoir temperatures are as follows: Engine a:, Engine b:, Engine c:, Rank the engines in order of their theoretically possible efficiency, from highest to lowest.
Answers (1)
For ceramic-matrix composites, high interfacial strength is desirable. (True, False)
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
Home » Engineering » A force 25 N makes an angle of 30,45 and 75 degree with x, y and z axis. What should be the corresponding force vector?
Sign Up Forgot Password?