A primary settling tank at a wastewater treatment plant has one influent flow (Qin) and two effluent flows (Qout and Qw) as indicated in the schematic below. The tank has an influent concentration (cin) of 220 mg/L of suspended solids, an effluent concentration (cout) of 45 mg/L of suspended solids, and a waste concentration (cw) of 10,000 mg/L of suspended solids. If the influent flow rate is 450 m3/hr, what is the waste flow rate
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “A primary settling tank at a wastewater treatment plant has one influent flow (Qin) and two effluent flows (Qout and Qw) as indicated in ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Twenty distinct cars park in the same parking lot every day. Ten of these cars are US-made, while the other ten are foreign-made. The parking lot has exactly twenty spaces, all in a row. so the cars park side by side.
Answers (1)
As the porosity of a refractory ceramic brick increases: (A) strength decreases, chemical resistance decreases, and thermal insulation increases (B) strength increases, chemical resistance increases, and thermal insulation decreases (C) strength
Answers (1)
What is stress corrosion cracking?
Answers (1)
Forward Error Correction (FEC) is a popular method of error control in networks where bandwidth utilization is a secondary issue.
Answers (1)
An uncovered swimming pool loses 1.0 inch of water off its 1,000 ft^2 surface each week due to evaporation. The heat of vaporization for water at the pool temperature is 1050 btu/lb. The cost of energy to heat the pool is $10.00 per million btu.
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)