Consider a variant of the thermostat of example 3.5. In this variant, there is only one temperature threshold, and to avoid chattering the thermostat simply leaves the heat on or off for at least a fixed amount of time. In the initial state, if the temperature is less than or equal to 20 degrees Celsius, it turns the heater on, and leaves it on for at least 30 seconds. After that, if the temperature is greater than 20 degrees, it turns the heater off and leaves it off for at least 2 minutes. It turns it on again only if the temperature is less than or equal to 20 degrees.
Design an FSM that behaves as described, assuming it reacts exactly once every 30 seconds.
Answers (2)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Consider a variant of the thermostat of example 3.5. In this variant, there is only one temperature threshold, and to avoid chattering the ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
The artifacts that expand what humans are able to do are called:.?
Answers (1)
What law What law directly affects your economic choices? directly affects your economic choices?
Answers (1)
If you have a "broken" line in your Alcohol thermometer: Group of answer choices Fill the 50mL flask with 30 mL of water and ice and try to cool it down Boil 30 mL of water in 50 mL and try to heat it up Replace with a new one Bring it to the garage
Answers (1)
The federal highway administration reports nearly
Answers (1)
Assign numMatches with the number of elements in userValues that equal matchValue. userValues has NUM_VALS elements. Ex: If userValues is {2, 1, 2, 2} and matchValue is 2, then numMatches should be 3.
Answers (1)
New Questions in Engineering
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
What is the main role of matrix in composites! a) - to transfer stress to the other phases b) - to protect phases from environment c) - to reduce the hardness d) - to enhance ductility
Answers (1)