When two mechanical waves have a displacement in opposite directions, and they overlap, what will the resulting wave look like and why?
The new wave will have the same displacement as the original waves due to constructive interference.
The new wave will have a smaller displacement than either of the original waves due to destructive interference.
The new wave will have a greater displacement than either of the original waves due to constructive interference.
The new wave will have the same displacement as the original waves due to destructive interference.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “When two mechanical waves have a displacement in opposite directions, and they overlap, what will the resulting wave look like and why? The ...” in 📙 Physics if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Identify the generic outer electron configuration for the halogens.
Answers (1)
Which type of element has the following general properties: solid at room temperature, high luster, good conductor of heat and electricity, malleable and ductile?
Answers (1)
In the vector addition lab, the following data was collected for determining the displacement from the door of the physics classroom to another location in the building: 2.0 m, West 22.0 m, South 25.0 m, East 9.0 m, North 4.
Answers (1)
True or False: When describing motion, there is no need to include the direction of motion.
Answers (2)
How do I obtain the poon?
Answers (2)
New Questions in Physics
Why does ice generally have very little friction when it is in contact with other materials?
Answers (1)
A stationary speed gun emits a microwave beam at 2.10*10^10Hz. It reflects off a car and returns 1030 Hz higher. What is the speed of the car?
Answers (1)
Discuss the changes in potential energy and kinetic energy and total energy for skateboarder going up and down on a half pipe ramp
Answers (1)
The diagram below shows rock is affected when water enters cracks in rock, freezes and becomes ice
Answers (1)
A vertical piston-cylinder device contains a gas at a pressure of 100 kPa. The piston has a mass of 5 kg and a diameter of 12 cm. Pressure of the gas is to be increased by placing some weights on the piston.
Answers (1)