How is the equilibrium constant of a reaction determined?
A. The molarity of products is divided by the molarity of reactants.
B. The molarity of reactants is subtracted from the molarity of products.
C. The molarity of reactants is divided by the molarity of products.
D. The molarity of products is multiplied by the molarity of reactants.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “How is the equilibrium constant of a reaction determined? A. The molarity of products is divided by the molarity of reactants. B. The ...” in 📙 Chemistry if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Calculate your experimentally determined percent mass of water in Manganese (II) sulfate monohydrate. Report your result to 2 or 3 significant figures, e. g. 9.8% or 10.2%.
Answers (1)
When 6.0 mol H2O reacts with 5.0 mol Al in the reaction below, 4.0 mol of Al are used up in the reaction. How many moles of Al are left over unreacted? Reaction: 2Al + 3H2O → Al2O3 + 3H2
Answers (1)
Which of the following would most likely cause a building to erode? A. acid rain B. the heat island effect C. heat pollution D. vehicle emissions
Answers (2)
The ideal gas constant, R has several different values that could be used. Which quantity causes these differences? a. pressure b. temperature c. volume d. moles
Answers (2)
g The combustion of 1.877 1.877 g of glucose, C 6 H 12 O 6 (s) C6H12O6 (s), in a bomb calorimeter with a heat capacity of 4.30 4.30 kJ/°C results in an increase in the temperature of the calorimeter and its contents from 22.71 22.71 °C to 29.51 29.
Answers (1)
New Questions in Chemistry
How many atoms of Hydrogen are in 67.2 L of H2 at STP?
Answers (1)
If a 45 mM phosphate solution (solution A) had an absorbance of 1.012. What would be the absorbance if 11 mL of solution A was used to prepare a 20.0 mL of a new phosphate solution. Write answer to three significant figures.
Answers (1)
Which choice best describes the specific heat of water compared with that of metals? A) The specific heat of water is less than the specific heat of metals. B) The specific heat of water is about the same as the specific heat of metals.
Answers (1)
Which of the following answer choices best describes J. J. Thomson's plum-pudding model? An atom is surrounded by a firm outer shell and contains positively charged particles in its core.
Answers (1)
A series of enzymes catalyze the reactions in the metabolic pathway X → Y → Z → A. Product A binds to the enzyme that converts X to Y at a position remote from its active site. This binding decreases the activity of the enzyme. What is substance X?
Answers (1)