Heat that flows by conduction is the transter of thermal energy between substances in contact. What must occur for this to
happen?
The two systems must be the same temperature,
The two systems must not be touching each another.
One system must have higher kinetic energy than the other system.
The thermal energy of one system must be the same as the thermal energy of the other system.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Heat that flows by conduction is the transter of thermal energy between substances in contact. What must occur for this to happen? The two ...” in 📙 Chemistry if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
What is the partial pressure of oxygen in a mixture that contains 0.30 moles of o2, 0.70 moles of n2, and 0.25 moles of ar with a total pressure of 1.1 atm?
Answers (1)
What effect does filtration have on water with a ph of 10?
Answers (1)
How do particles make up an atom and what are their locations?
Answers (1)
Calculate the density of a sample of liquid with a volume of 130 ml and a mass of 585 g.
Answers (1)
How do you use the periodic table?
Answers (1)
New Questions in Chemistry
For the reaction 2Fe + 3Cl2 → 2FeCl3 which of the following options gives the correct reactant:reactant ratio? Fe:Cl2 = 1:1 Fe:Cl2 = 2:3 Fe:Cl2 = 3:2 Fe:FeCl3 = 1:1
Answers (1)
A 2.575 g piece of gold (specific heat = 0.129 J/g°C) at a temperature of 75°C is placed into cold water at 10°C. If the gold loses 10.0 J of energy, what is its final temperature in the water? Enter your answer to the nearest whole number of °C.
Answers (1)
The complete combustion of gaseous sucrose at a constant pressure absorbs 544 kj of heapt per mole of surcrose. write the balance thermochemical equation for the reaction
Answers (1)
Find the acceleration if a car goes from 40 to 50 mph in 5 seconds
Answers (1)
What is the percent by mass of nahco3 in a solution containing 10 g of nahco3 dissolved in 400 ml of h2o?
Answers (1)