What statement best describes an independent variable?
a. The factor that's not changed by the experimenter and is impacted by the dependent variable
b. The factor that's changed by the experimenter and impacts the constant in an experiment
c. The factor that's changed by the experimenter and impacts the dependent variable
d. The factor that does not change, but impacts the constant in an experiment
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “What statement best describes an independent variable? a. The factor that's not changed by the experimenter and is impacted by the ...” in 📙 Chemistry if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Is ethanol polar or nonpolar? Explain.
Answers (1)
The mass of a compound is taken 5 times with the following results: 26.6mg, 26.3mg, 26.2mg, 26.4mg, and 26.1mg. If the true mass is 25.6mg, what is the percent relative error for this set of data? Round to the nearest hundredth of a percent.
Answers (1)
Decide whether each molecule is stable or not. decide whether each molecule would be diamagnetic or paramagnetic. calculate each molecule bond order.
Answers (1)
Which of the these is a balanced chemical equation? A) CO (g) + O2 (g) → CO2 (g) B) CO (g) + 2O2 (g) → 2CO2 (g) C) 2CO (g) + O2 (g) → 2CO2 (g) D) 2CO (g) + 2O2 (g) → 2CO2 (g)
Answers (1)
7. A 2.0 L container had 0.40 mol of He (g) and 0.60 mol of Ar (g) at 25°C. Which gas has a greater average kinetic energy? Which gas is traveling at a higher average speed? If Ar has an average speed of 431 m/s, what is the average speed of He?
Answers (1)
New Questions in Chemistry
77.60 ml of. 210 M NaOH are required to neutralize 25.05 ml ofH2SO4 solution in a titrationexperiment. Calculate the molarity and normality of theH2SO4 solution.
Answers (1)
A 25.0 g bold made of an alloy absorbed 250 J of heat as its temperature changed from 25.0 °C to 78.0 °C. What is the specific heat of the alloy?
Answers (1)
How is an areas topography determined?
Answers (1)
How to put a solution back into solution when it comes out of solution chemistry?
Answers (1)
When the isotonic saline solution described in part A is connected to an unknown solution via a semipermeable membrane, the unknown solution level drops.
Answers (1)