Ask Question
26 October, 09:38

Your network consists of two Layer 2 switches, SwitchA and SwitchB, and a Layer 3 switch, L3Switch. After an SVI configuration change on L3Switch by another network administrator, users in VLAN 5 can no longer access the resources on the servers in VLAN 10. Use the following commands to diagnose the problem on L3Switch, and then correct any issues you find. show ip route show vlan brief show run When you are finished. routes for all vlans should be in the L3Switch routing table. Tip: Click on the device icon (s) to open the CLI (s).

+3
Answers (1)
  1. 26 October, 13:30
    0
    The commands below are Used

    conf t

    int vlan 10

    no shut

    end

    copy run start
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Your network consists of two Layer 2 switches, SwitchA and SwitchB, and a Layer 3 switch, L3Switch. After an SVI configuration change on ...” in 📙 Computers & Technology if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers