The network board in a workstation is currently configured as follows: - network speed = auto - duplexing = autoThe workstation is experiencing poor network performance, and you suspect that the network board is not correctly detecting the network speed and duplex settings. Upon investigation, you find hat it is running at 10 Mbps half-duplex. You know that your network switch is capable of much faster throughout. To fix this issue, you decide to manually configure these settings on the workstation. Before you do so, you need to verify the configuration of the switch port that the workstation is connected to. Given that it is a Cisco switch, which commands can be used on the switch to show a list o all switch ports and their current settings. (Select two.) A. show running-config interfaceB. show interface ethernet countersC. show interface switchportD. show interfaceE. show interface capabilities

Question

Computers & Technology

Nathen Buchanan

8 July, 00:57

The network board in a workstation is currently configured as follows: - network speed = auto - duplexing = autoThe workstation is experiencing poor network performance, and you suspect that the network board is not correctly detecting the network speed and duplex settings. Upon investigation, you find hat it is running at 10 Mbps half-duplex. You know that your network switch is capable of much faster throughout. To fix this issue, you decide to manually configure these settings on the workstation. Before you do so, you need to verify the configuration of the switch port that the workstation is connected to. Given that it is a Cisco switch, which commands can be used on the switch to show a list o all switch ports and their current settings. (Select two.) A. show running-config interfaceB. show interface ethernet countersC. show interface switchportD. show interfaceE. show interface capabilities

+5

Answers (2)

Know the Answer?

Ashton Neal · Answer 1

The commands that can be used on the switch to show a list o all switch ports and their current settings are options A and D

A ... show running-config interface

D. show interface

Explanation:

For all Cisco switches, the function of (A) is to view, the running configuration for a specific port channel. The port channel could be the router, switch, or firewall's current configuration.

To view the summary of summary of the router interfaces, the (B) show interface command is used.

The combination of these two commands gives the desired output when run on the switch by displaying a list o all switch ports along with their current settings.

Amirah · Answer 2

Options A and D

Explanation:

Show running-configuration is an general display of the switch configuration, it includes the encryption services enabled, the VLAN created and the configuration of the ports of the switch, among other options.

On the other hand, show interfaces shows an extensive display of information of all of the switch's ports, including not only duplex and speed, but also, bandwidth, quantity of packets received and sent, flow control, etc.