Ask Question
18 October, 20:20

You have expanded your current LAN from about 200 hosts to over 350 hosts. The first 200 hosts were getting IP addresses from a scope configured with the address range 10.1.1.1 to 10.1.1.250 with prefix length 24. You don't want to change the IP addressing scheme for the existing hosts, but you need to accommodate all 350 hosts with DHCP-assigned addresses. You don't have any VLANs or routers configured. What should you configure?

+3
Answers (1)
  1. 18 October, 20:43
    0
    You should configure a DHCP superscope.

    Explanation:

    The problem here is that after the host #200 is connected to your LAN, the next host IP is going to be the APIPA Address (Automatic Private Internet Protocol Addressing) because the server don't have any IP to offer, in windows server you must configure a feature of the DHCP service called superscope. A superscope is a feature of Windows Server DHCP that enables to serve multiple IP subnets to the same physical LAN, this feature will enable another subnet in your system so any host connected must have a valid IP address.
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “You have expanded your current LAN from about 200 hosts to over 350 hosts. The first 200 hosts were getting IP addresses from a scope ...” in 📙 Computers & Technology if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers