An electric current is passed through a wire of 1 mm in diameter and 10 cm long. The wire is submerged in liquid water at atmospheric pressure, and the current is increased until the water boils. For this situation, the convection coefficient is 5000 W / (m²K), and the water temperature will be 100°C.
How much electric power must be supplied to the wire to maintain the wire surface temperature at 114°C?
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “An electric current is passed through a wire of 1 mm in diameter and 10 cm long. The wire is submerged in liquid water at atmospheric ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Steam enters a turbine operating at steady state at 600°F and 200 lbf/in^2 with a velocity of 80 ft/s and leaves as saturated vapor at 5 lbf/in^2 with a velocity of 300 ft/s. The power developed by the turbine is 200 horsepower.
Answers (1)
On what date would it be exactly 9 months since 9/06/19 I need to know for my science project so don't delete
Answers (1)
If, when a relay is energized, you measure 0.05 VAC across a set of normally open contacts, the A. relay is operating properly B. contacts must be burnt C. contacts must be pitted D. coil is open
Answers (1)
Explain the reasons for abandoning a well.
Answers (1)
Match the following foliated rocks with their metamorphic grade: A. Schist 1. Highest grade B. Slate 2. Second-highest grade C. Gneiss 3. Second-lowest grade D. Phyllite 4. Lowest grade
Answers (1)
New Questions in Engineering
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
What is the main role of matrix in composites! a) - to transfer stress to the other phases b) - to protect phases from environment c) - to reduce the hardness d) - to enhance ductility
Answers (1)