What is the black diamond at 19 3/16 on a tape measure used for?

An engineering drawing shows the: (A) dimensions, tolerances, cost, and sales or use volume of a component. (B) dimensions, tolerances, materials, and finishes of a component.

Which if of the following is not a part of a program block

A refrigerator that consumes 3 kW of electricity when running and has a coefficient of performance of 1.5 is placed in a well-sealed room, and is plugged in with its door open.

Steam enters an insulated turbine at 100 bar, 400oC. At the exit, the pressure and quality are 200 kPa and 0.47, respectively. Determine the power produced (kW) by the turbine if the mass flow rate is 1.99 kg/s.

Can a real refrigerator have higher COP than the COP of the Carnot refrigerator?

Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.

The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius

Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.

What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution

The controller can be considered the brain of closed loop system