Salvage ethnography is the effort to ensure that ethnography remains an important part of anthropology. recording of linguistic diversity that is about to become extinct. recording of cultural diversity that is threatened by Westernization. recovering of an archaeological site that is about to be destroyed by a public building or road. rewriting of an ethnography that was written in the ethnographic present.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Salvage ethnography is the effort to ensure that ethnography remains an important part of anthropology. recording of linguistic diversity ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Which valve assembly would you rather have in your vehicle?
Answers (1)
Design a multiple-output logic circuit whose input is a BCD digit and whose outputs are defined as follows: 1f: Detects input digits that are divisible by 4, 2f: Detects numbers greater than or equal to 3, 3f: Detects numbers less than 7.
Answers (1)
In remote areas, your gps devices may lose reception. It's a good idea to have a
Answers (2)
Water flows at 5 Liters/s through a horizontal pipe that narrows smoothly from 10 cm diameter to 5 cm diameter. A pressure gauge in the narrow section reads 50 kPa. What is the reading of the pressure gauge in the wide section
Answers (1)
A force 25 N makes an angle of 30,45 and 75 degree with x, y and z axis. What should be the corresponding force vector?
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)