Engineering

Monserrat Rivas

18 November, 02:09

While discussing armature testing: Technician A says to test for shorts, place the ohmmeter leads on a commutator segment and armature shaft. Technician B says that continuity should exist between the commutator and the armature shaft. Who is correct?

+5

Answers (1)

Know the Answer?

Not Sure About the Answer?

Get an answer to your question ✅ “While discussing armature testing: Technician A says to test for shorts, place the ohmmeter leads on a commutator segment and armature ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.

Search for Other Answers

You Might be Interested in

What should you following distance be at night

A tensile test is performed on a metal specimen, and it is found that a true plastic strain of 0.22 is produced when a true stress of 572 MPa (82960 psi) is applied; for the same metal, the value of K in the equation is 860 MPa (124700 psi).

A household refrigerator runs one-fourth of the time and removes heat from the food compartment at an average rate of 800 kJ/h. If the COP of the refrigerator is 2.4, determine the power the refrigerator draws when running.

is Compression ratio decreased when a large volume of combustion chamber deposits accumulate in the engine?

The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200K and 400K, respectively. For each case, evalutate the net power developed by the cycle, in kW, and the thermal efficiency.

New Questions in Engineering

Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.

The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius

Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.

What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution

The controller can be considered the brain of closed loop system