Which statement best describes an integrated circuit?
A.
a device for tracking power transfer losses between a power-generating station and its substations
B.
a very large system of electronic circuits used to transfer electrical power between electrical networks
C.
a very small semiconductor wafer with an entire electrical circuit etched on it using a special manufacturing technique
D.
a complex electronic device capable of working with both analog and digital signals
E.
a miniature version of electronic components that is used to simulate an electronic circuit
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Which statement best describes an integrated circuit? A. a device for tracking power transfer losses between a power-generating station and ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
A 3.7 g mass is released from rest at C which has a height of 1.1 m above the base of a loop-the-loop and a radius of 0.2 m. The acceleration of gravity is 9.8 m/s 2. 1.1 m 0.2 m B D C A 3.
Answers (1)
Define the stress and strength? A material has yield strength 100 kpsi. A cantilever beam has length 10 in and a load of 100 Lbf is applied at the free end. The beam cross section is rectangular 2""x5'.
Answers (1)
2. Suppose you yell in a canyon. You hear the echo of your voice 0.8 seconds later with an amplitude 5% as loud. But, that will echo back again from your side, so you will hear another echo 0.
Answers (1)
Composite materials such as GFRP have low strength to weight ratio. a) - True b) - False
Answers (1)
What is the weight of a glider with a mass of 5.3 grams? (Hint: watch your units!)
Answers (1)
New Questions in Engineering
16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.
Answers (1)
The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder
Answers (1)
What factors are likely to promote the formation of stress corrosion cracks?
Answers (1)
Find the mass if the force is 18 N and the acceleration is 2 m/s2
Answers (2)
Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion
Answers (1)