You have removed a very large, thick plate of steel (AISI 1010) from your heat treat oven and have placed it on a large insulated surface; the steel is now at a uniform initial temperature of 600.0°C. You now cool the exposed top surface of the steel using high-velocity cooling fluid; which keeps the cooled surface at a constant 30.0°C (assume the other surface is not losing any heat). How long will you need to run the coolant to cool the steel at a depth of 4.20cm to a temperature of 60.0°C?
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “You have removed a very large, thick plate of steel (AISI 1010) from your heat treat oven and have placed it on a large insulated surface; ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
What is the difference between geosynchronous and non-geosynchronous satellites? What are the pros and cons of these two types of satellites?
Answers (1)
A CSTR is being used to carry out a certain reaction isothermally in the liquid phase. It is observed that the conversion in the CSTR is actually higher than that which was predicted from the design equations.
Answers (1)
You are a part of the team that is creating the process routing for a new product. Which of the following information is NOT necessary to include in the process routing?
Answers (1)
Motion is defined as a change in an object's position when compared to other objects around it. Mary Ann was watching a slug crawl across the driveway. She saw that a small rock was beside the slug when she first started watching it.
Answers (1)
A certain metal has a resistivity of 1.68 * 10-8 Ω ∙ m. You have a long spool of wire made from this metal. If this wire has a diameter of 0.15 mm, how long should you cut a segment so its resistance will be 15 Ω?
Answers (1)
New Questions in Engineering
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
What is the main role of matrix in composites! a) - to transfer stress to the other phases b) - to protect phases from environment c) - to reduce the hardness d) - to enhance ductility
Answers (1)