Sign In
Ask Question
Engineering
Bridgett
30 July, 03:53
What is a gearbox ratio
+2
Answers (
1
)
Deborah Haney
30 July, 05:19
0
Divide one teeth count by the other.
Now that you know how many teeth are on each gear, you can find the gear ratio relatively simply. Divide the driven gear teeth by the drive gear teeth. Depending on your assignment, you may write your answer as a decimal, a fraction, or in ratio
Comment
Complaint
Link
Know the Answer?
Answer
Not Sure About the Answer?
Get an answer to your question ✅
“What is a gearbox ratio ...”
in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
1. A spur gear made of bronze drives a mid steel pinion with angular velocity ratio of 13 / 2 : 1. Thepressure angle is 14 1/2°. It transmits 5 kW at 1800 r. p. m. of pinion.
Answers (1)
11. A heat engine operates between two reservoirs at 800 and 20°C. One-half of the work output of the heat engine is used to drive a Carnot heat pump that removes heat from the cold surroundings at 2°C and transfers it to a house maintained at 22°C.
Answers (1)
Technician A says that clutch slippage can be a result of excessively strong pressure plate spring (s). Technician B says that when replacing the friction disc, it is good practice to also replace the pressure plate. Who is correct?
Answers (1)
The inlet for a high-bypass-ratio turbofan engine has an area A1 of 6.0 m 2 and is designed to have an inlet Mach number M~ of 0.6. Determine the additive drag at the flight conditions of sea-level static test and Mach number of 0.
Answers (1)
Steam is to be condensed in the condenser of a steam power plant at a temperature of 50°C with cooling water from a nearby lake, which enters the tubes of the condenser at 18°C at a rate of 97 kg/s and leaves at 27°C.
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
Home
»
Engineering
» What is a gearbox ratio
Sign In
Sign Up
Forgot Password?