8. What side length would you specify if you were required to create a regular
hexagonal plate that was comprised of 33 cm - of sheet metal?
Bonus: Sketch the hexagon, dimension the side length on the sketch to 0.1 cm,
and indicate your grid spacing. Justify your dimension.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “8. What side length would you specify if you were required to create a regular hexagonal plate that was comprised of 33 cm - of sheet ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Explain how the principles of Gay-Lussac's law apply to the normal operation of a forced-air type of air-conditioning system. How does the system move heat and produce a cooling effect?
Answers (1)
According to the trend in device scaling historically observed by Moore's Law, the number of transistors on a chip in 2025 should be how many times the number in 2015?
Answers (1)
A 25-kg cast-iron wood-burning stove contains 5kg of soft pine wood and 1 kg of air. All the masses are at room temperature, 20 degree C, and pressure, 101 kPa. The wood now burns and heats all the mass uniformly, releasing 1500W.
Answers (1)
If the head loss in a 30 m of length of a 75-mm-diameter pipe is 7.6 m for a given flow rate of water, what is the total drag force exerted by the water on this length of pipe?
Answers (1)
Specific cutting energy increases with increasing the cutting speed. a) True b) False
Answers (1)
New Questions in Engineering
At steady state, a power cycle having a thermal efficiency of 38% generates 100 MW of electricity while discharging energy by heat transfer to cooling water at an average temperature of 70 F.
Answers (1)
What is the definition of a fluid?
Answers (1)
You are ordering steel cable for a 250 foot long zip-line you are building in your back yard. The cable can be ordered in diameters with 1/16 inch increments. (1/16, 1/8, 3/16, 1/4, 5/16, 3/8, etc.
Answers (2)
Which of the following statements is LEAST-Likely true? A) Do not attempt to unseat the beads of an inflated tire. B) Do not strike the tire or rim with a hammer. C) A hammer is sometimes necessary when removing a passenger car tire.
Answers (1)
What is the pitch circle diameter of a 50-tooth spur gear having a circular pitch of 0.375 inch
Answers (1)