Engineering

Jazz

26 April, 13:09

You built an android that has a subcircuit containing a power supply, a tactile sensor, and a fuse where safe operation should keep current below 250 mA. You measured that your sensor is dissipating 12 W, the power supply is pro - viding 12.2 W, and the voltage drop across the fuse is 500 mV. Is your circuit properly protected?

+5

Answers (1)

Know the Answer?

Not Sure About the Answer?

Get an answer to your question ✅ “You built an android that has a subcircuit containing a power supply, a tactile sensor, and a fuse where safe operation should keep current ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.

Search for Other Answers

You Might be Interested in

Micrometers with a vernier graduation are capable of taking readings to the nearest 0.0001 in. a) - True b) - false

True/False An anemometer displays wind direction, wind speed, altitude and type of precipitation

On a 2001 Honda Civic Brake Master Cylinder, what is the piston-to-pushrod clearance? a. 0-0.4 mm b. 0.5-0.7 mm c. 5-7 mm d. 0-4 mm

A finished, tapered workpiece has an included angle of 70 degrees. If the taper is nade vith the compound, how many degrees should tha setting be on the swivel base? A. 70 B. 140 C. 20 D. 35

Your organization spans multiple geographical locations. The name resolution is happening with a single DNS zone for the entire organization. Which of the following is likely to happen if you continue with the single DNS zone? [Choose all that apply.

New Questions in Engineering

5) A 80-kg man has a total foot imprint area of 480 cm2. Determine the pressure this man exerts on the ground if (a) he stands on both feet and (b) he stands on one foot.

A car with an initial speed of 50 km/h accelerates at 5000 km/h2 along a straight road. a. How long will it take to reach a speed of 120 km/h?

If high beam headlights are used improperly, it could cause glare for an oncoming driver or reduce their visibility greatly, increasing the possibility of a collision. a) b) True False

The value of the critical Reynolds number for the flow over a flat plate is 5 x10^5. The significance of the value is: (a) The boundary layer will be turbulent where the Reynolds number is less than this value.

The specifications of an electronic device are 24 / - 0.4 Amps. When the device exceeds specifications the average quality cost is $32.00. A sample of the devices had an average value of 23.9 Amps and a standard deviation of 0.211 Amps.