Which of the sequences below represents the various steels types in order of decreasing hardness?
a. High-carbon > Low-carbon > Medium-carbon
b. Low-carbon > Medium-carbon > High-carbon
c. High-carbon > Medium-carbon > Low-carbon
d. Medium-carbon > High-carbon > Low-carbon
e. Medium-carbon > Low-carbon > High-carbon
f. Low-carbon > High-carbon > Low-carbon
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Which of the sequences below represents the various steels types in order of decreasing hardness? a. High-carbon > Low-carbon > ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
At steady state, a refrigerator whose coefficient of performance is 3 removes energy by heat transfer from a freezer compartment at 0 degrees C at the rate of 6000 kJ/hr and discharges energy by heat transfer to the surroundings, which are at 20
Answers (1)
Many vectors are designed to double in size whenever a new element is inserted into a full vector. This operation may entail allocating a new array that is twice the size of the original, and then copying the original elements into the new array
Answers (1)
What does the General Duty Clause require employers to do?
Answers (1)
Electric power is to be generated by installing a hydraulic turbine-generator at a site 138 m below the free surface of a large water reservoir that can supply water at a rate of 2400 kg/s steadily. Determine the power generation potential.
Answers (1)
Consider a variant of the thermostat of example 3.5. In this variant, there is only one temperature threshold, and to avoid chattering the thermostat simply leaves the heat on or off for at least a fixed amount of time.
Answers (2)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)