Engineering

Mohamed

19 May, 01:44

The convection heat transfer coefficient for a clothed person standing in moving air is expressed as h 5 14.8V0.69 for 0.15, V, 1.5 m/s, where V is the air velocity. For a person with a body surface area of 1.7 m2 and an average surface temperature of 29°C, determine the rate of heat loss from the person in windy air at 10°C by convection for air velocities of (a) 0.5 m/s, (b) 1.0 m/s, and (c) 1.5 m/s.

+1

Answers (1)

Know the Answer?

Not Sure About the Answer?

Get an answer to your question ✅ “The convection heat transfer coefficient for a clothed person standing in moving air is expressed as h 5 14.8V0.69 for 0.15, V, 1.5 m/s, ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.

Search for Other Answers

You Might be Interested in

Fluorescent troffers are a type of _ lighting fixture a surface-mounted b. recessed c. suspended d. track-mounted

4. An adiabatic tank of negligible heat capacity and 1 m3 volume is connected to a pipeline containing steam at 10 bar and 200°C, filled with steam until the pressure equilibrates, and disconnected from the pipeline.

Feedback control requires being able to sense the variable being controlled. Because electrical signals can be transmitted, amplified, and processed easily, often we want a sensor whose output is a voltage or current proportional to the variable

What are the three basic components of a limit switch

1. You have a Co-Cr alloy with Young's Modulus: 645 MPa, Poisson ratio 0.28, and yield strength 501 MPa for that alloy when used in a medical device.

New Questions in Engineering

The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius

Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.

What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution

The controller can be considered the brain of closed loop system

What is the main role of matrix in composites! a) - to transfer stress to the other phases b) - to protect phases from environment c) - to reduce the hardness d) - to enhance ductility