You work in Madison, Wisconsin. It is January and the area has been hit with bad weather. Another weather front is expected to arrive this afternoon and dump another foot of snow. Your branch manager decides to close the office early today. He asks you to send an e-mail to all the staff informing them of his decision. Which would be the best first sentence of your e-mail?
The office will close at noon today because of the snowstorm.
Weather forecasters are predicting a blizzard this afternoon, so, as a result of this news, our supervisor has decided to close the office at noon so people can travel home safely.
Channel 7 News just announced during its morning weather report that a major blizzard is coming our way, so the office will be closed today.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “You work in Madison, Wisconsin. It is January and the area has been hit with bad weather. Another weather front is expected to arrive this ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
A cylindrical hot water storage tank (see sketch) for a set of collectors is located in the basement of a dwelling. The tank is made of 0.080" thick steel and insulated with 3" thick fiberglass batt insulation.
Answers (1)
What is the inch equivalent of 1 millimeter
Answers (1)
A square isothermal chip is of width w = 5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at T[infinity] = 15°C.
Answers (1)
What is Potential flow?
Answers (1)
A 20 foot length of two-conductor 26 AWG copper wire is used to connect a single strain gage into a quarter-bridge circuit. If each conductor has a resistance of 20.
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)