Engineering

Harper Lang

13 June, 20:31

What is the main difference between a generator and a motor?

A

Generator - mechanical energy to electrical energy

Motor - electrical energy to mechanical energy

a motor and generator only use electrical energy

Generator - electrical energy to mechanical energy

Motor - mechanical energy to electrical energy

D

They are the same machine.

+4

Answers (1)

Know the Answer?

Not Sure About the Answer?

Get an answer to your question ✅ “What is the main difference between a generator and a motor? A Generator - mechanical energy to electrical energy Motor - electrical energy ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.

Search for Other Answers

You Might be Interested in

What is clearance? What is backlash? What is interference? Explain briefly.

The pulley has mass 12.0 kg, outer radius Ro=250 mm, inner radius Ri=200 mm, and radius of gyration kO=231 mm. Cylinder A weighs 71.0 N. Assume there is no friction between the pulley and its axle and that the rope is massless.

Describe harmful effect associated with extraction of Aluminum, Gold and Copper. Discuss each individually.

Part of a good computer posture is to sit up straight with feet flat on the floor t or f

Technician A says that load-carrying ball joints should always have some play in them. Technician B says that follower ball joints should never have some play in them. Who is correct? a. Technician A b. Technician B c. Both A and B d.

New Questions in Engineering

Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.

The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius

Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.

What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution

The controller can be considered the brain of closed loop system