Which of the following was a difference between life in England and in the British North American colonies? A. The right to vote was more widespread in England than it was in the colonies. B. British colonists did not have an established church. C. There was greater social and economic equality in England than in the colonies. D. British colonists could not hold assemblies or meetings.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Which of the following was a difference between life in England and in the British North American colonies? A. The right to vote was more ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
An engineering drawing shows the: (A) dimensions, tolerances, cost, and sales or use volume of a component. (B) dimensions, tolerances, materials, and finishes of a component.
Answers (1)
Which if of the following is not a part of a program block
Answers (1)
A refrigerator that consumes 3 kW of electricity when running and has a coefficient of performance of 1.5 is placed in a well-sealed room, and is plugged in with its door open.
Answers (1)
Steam enters an insulated turbine at 100 bar, 400oC. At the exit, the pressure and quality are 200 kPa and 0.47, respectively. Determine the power produced (kW) by the turbine if the mass flow rate is 1.99 kg/s.
Answers (1)
Can a real refrigerator have higher COP than the COP of the Carnot refrigerator?
Answers (2)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)