If a tank can be pressurized to a maximum of 500 lb/in2 (psi), and the area is 20 in2. What is the most force that should be exerted by the system?

A) 25 lbs

B) 10,000 lbs

C) 250 lbs

D) 1000 lbs

1. Nitrogen at an initial state of 300 K, 150 kPa, and 0.2 m3 is compressed slowly in an isothermal process to a final pressure of 800 kPa. Determine the work done during this process.

To convert a whole number to a fraction the number can be written over a denominator of

Nathan your back!

Francine solves the system of equations using the linear combination method. 4x+3y=-13x-5y=4 Which steps would allow her to eliminate the x terms in the system of equations? Multiply 4x+3y=-1 by - 4. Multiply 3x-5y=4 by 3.

Air is contained in a variable-load piston-cylinder device equipped with a paddle wheel. Initially, air is at 400 kPa and 17°C. The paddle wheel is now turned by an external electric motor until 72 kJ/kg of work has been transferred to air.

16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.

The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder

What factors are likely to promote the formation of stress corrosion cracks?

Find the mass if the force is 18 N and the acceleration is 2 m/s2

Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion