A signal suspected to be of the nominal form y (t) = 5 sin 1000 mV is measured by a first-order instrument having a time constant of 100 ms and K 1 V/V. It is then to be passed through a second-order amplifier having a K = 100 V/V, a natural frequency of 15,000 Hz, and a damping ratio of 0.8. What is the expected form of the output signal, y (t) ? Estimate the dynamic error and phase lag in the output. Is this system a good choice here? If not, do you have any suggestions?
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “A signal suspected to be of the nominal form y (t) = 5 sin 1000 mV is measured by a first-order instrument having a time constant of 100 ms ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Line (s) indicates passing is allowed if there are no oncoming cars. O A solid yellow O Double solid yellow Broken white Broken yellow
Answers (1)
Write the equation for the output voltage as a function of the input voltage (sketch a circuit defining your variables). The maximum current coming out/into the op-amp output (terminal 6) is approximately 20 mA.
Answers (1)
Which of the following would NOT fall into one of the WHMIS 1988 classes?
Answers (1)
The principal value of a Pareto diagram is as a
Answers (1)
Engineer A is an assistant director of public works in Somecity. As part of his job, Engineer A is involved in selecting and hiring engineering consultants for projects in Somecity. These projects may involve local, state, and federal funds.
Answers (1)
New Questions in Engineering
What is the definition of a fluid?
Answers (1)
You are ordering steel cable for a 250 foot long zip-line you are building in your back yard. The cable can be ordered in diameters with 1/16 inch increments. (1/16, 1/8, 3/16, 1/4, 5/16, 3/8, etc.
Answers (2)
Which of the following statements is LEAST-Likely true? A) Do not attempt to unseat the beads of an inflated tire. B) Do not strike the tire or rim with a hammer. C) A hammer is sometimes necessary when removing a passenger car tire.
Answers (1)
What is the pitch circle diameter of a 50-tooth spur gear having a circular pitch of 0.375 inch
Answers (1)
Emergency plans are being formulated so that rapid action can be taken in the event of an equipment failure. It is predicted that if a particular pipeline were to rupture, it would release ammonia at a rate of 100 lb/s.
Answers (1)