A desktop computer is to be cooled by a fan whose flow rate is 0.34 m3 / min. Determine the mass flow rate of air through the fan at an elevation of 3400 m where the air density is 0.7 kg/m3. Also, if the average velocity of air is not to exceed 110 m/min, determine the diameter of the casing of the fan. (Page 215).
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “A desktop computer is to be cooled by a fan whose flow rate is 0.34 m3 / min. Determine the mass flow rate of air through the fan at an ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
The net potential energy between two adjacent ions, EN, may be represented by the sum of Equations 2.9 and 2.11; that is, (2.17) EN = A/r+B/r^n Calculate the bonding energy E0 in terms of the parameters A, B, and n using the following procedure: 1.
Answers (1)
2. What does the phrase "melting pot" in paragraph 11 imply about American culture? A American culture is formed as white Americans steal facets from other cultures without their consideration.
Answers (1)
Water circulates throughout a house in a hot water heating system. If the water is pumped at a speed of 0.50m/s through a 4.0-cm diameter pipe in the basement under a pressure of 3.03x10^5 Pa, what will be the velocity and pressure in a 2.
Answers (1)
A particle is emitted from a smoke stack with diameter of 0.05 mm. In order to determine how far downstream it travels it is important to find its terminal downward velocity.
Answers (1)
What is the value of the energy (in Joules) stored by the mobile phone battery (capacity of 1.8 Ah), if it is rated at 3.7 V
Answers (2)
New Questions in Engineering
16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.
Answers (1)
The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder
Answers (1)
What factors are likely to promote the formation of stress corrosion cracks?
Answers (1)
Find the mass if the force is 18 N and the acceleration is 2 m/s2
Answers (2)
Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion
Answers (1)