Sign In
Ask Question
Engineering
Josiah Vincent
14 May, 13:48
What's the monomer? Show the structure.
+4
Answers (
1
)
Griffen
14 May, 14:23
0
In order to understand a monomer let's first see the structure of a polymer. As an example, in the first figure polyethylene (or polyethene) is shown. This polymer, like every other one, is composed of many repeated subunits, these subunits are called monomer. In the second figure, polyethylene's monomer is shown.
Comment
Complaint
Link
Know the Answer?
Answer
Not Sure About the Answer?
Get an answer to your question ✅
“What's the monomer? Show the structure. ...”
in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
On a average work day more than work place firs are reorted
Answers (1)
A 4-kW electric heater runs for 2 hours to raise the room temperature to the desired level. Determine the amount of electric energy used in both kWh and kJ.
Answers (1)
Explain why it was important to clean each piece of metal you used with sandpaper prior to doing the experiment.
Answers (1)
What is the mass in both slugs and kilograms of a 1000-lb beam?
Answers (1)
Calculate the pressure drop in a duct (measured by a differential oil manometer) if the differential height between the two fluid columns is 3.2 cm and the density of oil is 860 kg/m3.
Answers (1)
New Questions in Engineering
In 2008 502 motorcyclists fire in Florida - an increase from The number killed in 2004
Answers (1)
A 1'x1' square concrete pile is embedded 20 feet in clay with an undrained shear strength of 2,800 psf. Based on the LaTeX: / alphaα-method and LaTeX: / alphaα-values of Terzaghi et al.
Answers (1)
Consider a sinusoidal oscillator consisting of an amplifier having a frequency-independent gain A (where A is positive) and a second-order bandpass filter with a pole frequency ω0, a pole Q denoted Q, and a positive center-frequency gain K.
Answers (1)
A mass is dropped (i. e., initial v=0) from the top of a tall building at a height of 300 m. If we neglect air friction, find the velocity of the object when it hits the ground (m/s). g = 9.8 m/s^2
Answers (1)
An engineer is considering time of convergence in a new Layer 3 environment design. Which two attributes must be considered? (Choose two) A. Addition of a valid forwarding path B. Loss of a valid forwarding path C. SPT timers update D.
Answers (1)
Home
»
Engineering
» What's the monomer? Show the structure.
Sign In
Sign Up
Forgot Password?