Ask Question
EngineeringEngineering
28 January, 22:40

Pro-Cut Rotor Matching Systems provide a non-directional finish without performing additional swirl sanding - true or false?

+3
Answers (1)
  1. 29 January, 01:01
    0
    Answer:True

    Explanation:Rotor matching is a term used to describe the process through a brake rotor is aligned to the hub and bearing assembly to produce a smooth, flat, and straight friction surface.

    Rotor matching is an essential process which is required to prevent swirling of a break when a vehicle is stopping, rotor matching is needed for efficient and effective break system performance as it is one of the main determinant factors for accidents arising from break failures.
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Pro-Cut Rotor Matching Systems provide a non-directional finish without performing additional swirl sanding - true or false? ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
An engineering drawing shows the: (A) dimensions, tolerances, cost, and sales or use volume of a component. (B) dimensions, tolerances, materials, and finishes of a component.
Answers (1)
Which if of the following is not a part of a program block
Answers (1)
A refrigerator that consumes 3 kW of electricity when running and has a coefficient of performance of 1.5 is placed in a well-sealed room, and is plugged in with its door open.
Answers (1)
Steam enters an insulated turbine at 100 bar, 400oC. At the exit, the pressure and quality are 200 kPa and 0.47, respectively. Determine the power produced (kW) by the turbine if the mass flow rate is 1.99 kg/s.
Answers (1)
Can a real refrigerator have higher COP than the COP of the Carnot refrigerator?
Answers (2)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
Home » Engineering » Pro-Cut Rotor Matching Systems provide a non-directional finish without performing additional swirl sanding - true or false?
Sign Up Forgot Password?