One who is trained in math, science and physics in order to work in a branch of engineering

how much time does it take for a product depivery plane flying at a speed of 145 kilometers to travel a distance of 1800 kilometers?

What are atomic bombs made out of Just wondering

The bars of the truss each have a cross-sectional area of 1.25 in2. If the maximum average normal stress in any bar is not to exceed 20 ksi, determine the maximum magnitude P of the loads that can be applied to the truss.

You are comparing distillation column designs at 1 atm and 3 atm total pressure for a particular separation. You have the same feed in both cases, and the feed is a saturated liquid in both cases.

A 24-foot simple span laterally supported beam is required to carry a uniformly distributed load of 8.0 klf. Select the lightest A992 steel beams for each of these combinations of load considering only flexure.

16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.

The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder

What factors are likely to promote the formation of stress corrosion cracks?

Find the mass if the force is 18 N and the acceleration is 2 m/s2

Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion