Ask Question
EngineeringEngineering
22 August, 13:19

What is a "gob" as described in the glass making process?

+5
Answers (1)
  1. 22 August, 14:42
    0
    Step1

    Gob is the primary element in the glass production. Gob is the hot molten glass which can shape according to the shape of container.

    Step2

    Gob is filled in the mold in glass production. The shape of gob is different for different glass product in glass production process. So, the shape of gob is very important parameter for glass production. This gob is filled in the mold by guided method or the gravity method.
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “What is a "gob" as described in the glass making process? ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
A hollow aluminum sphere (kAl = 234 W/mK), with an electrical heater in the center, is used in tests to determine the thermal conductivity of insulating materials. The inner and outer radii of the sphere are 0.18 and 0.
Answers (1)
An employee may reveal his employer's confidential information only (check all that apply) when required by law or court order with a fully informed employer's consent when those confidences, if left undisclosed, would constitute a threat to the
Answers (1)
Describe what V1-V4 is
Answers (1)
Which two investment options would be best if you are 20 years old just starting to see if I want to retire when you're 70 consider the kind of investment rate of return level of risk and other factors
Answers (2)
New Questions in Engineering
If a vehicle is equipped with radial tires, the tires should be mounted on which thing?
Answers (1)
4. Porcelain enamel is sometimes referred to as A. "glass lining" B. kaolin C. vitreous enamel D. Both A and C.
Answers (1)
In casting experiments performed using a certain alloy and type of sand mold, it took 155 sec for a cube-shaped casting to solidify. The cube was 50 mm on a side. (a) Determine the value of the mold constant Cm in Chvorinov's Rule.
Answers (1)
The maximum stress in a section of a circular tube subject to a torque is τmax = 22 MPa. If the inner diameter is Di = 3.75 cm and the outer diameter is Do = 5.
Answers (1)
Choose the true statement from those shown below: A Merchant Account allows you to use SSL on your web site.
Answers (1)
Home » Engineering » What is a "gob" as described in the glass making process?
Sign Up Forgot Password?