Ask Question
EngineeringEngineering
14 December, 20:12

Describe the anodising process, with diagrams.

+4
Answers (1)
  1. 14 December, 23:47
    0
    Anodising process is method to protect the metal surface from corrosion. The metal surface get corroded due to presence of oxygen and due this the material loose strength.

    Anodising process is also used to provide good appearance of metals. This is also called electroplating coating.

    In this process metal dipped in the acidic electrolyte and pass the current, due which oxidation takes place and produce a layer on the metal surface.
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Describe the anodising process, with diagrams. ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
A glass matrix is reinforced with unidirectional silicon carbide fibers and loaded in longitudinal tension until matrix failure. Determine the minimum fiber volume ratio, so that the composite does not fail catastrophically
No Answers
5 cause of a electrical problem
Answers (1)
According to the increasing order of toughness, list the following materials. Pearlite, martensite, bainite, spheroidite.
Answers (1)
Air is flowing in an insulated duct at a rate of 2 kg/sec. Air enters the duct at 40 oC and 8-kW of heat is added with a electric resistance heater. Find the exit temperature of air. (Cp=1.005 kJ/kgK) a) 44 b) 30 c) 54 d) 60
Answers (1)
Under a construction management (CM) contract, should the CM firm's responsibilities normally begin at the construction phase, the design phase, the planning phase, or the conceptual phase?
Answers (1)
New Questions in Engineering
Though still is on the margins of the global agro-food system, organic farming practices are on the rise in the core. In growing crops and raising livestock organically, which of the following are permitted? composted cow manure
Answers (1)
Technician A says that a magnetic field can be created by current flow. Technician B says that current can be induced by moving a wire through a magnetic field. Who is right?
Answers (1)
9.17 LAB: Name format Many documents use a specific format for a person's name. Write a program whose input is: firstName middleName lastName, and whose output is: lastName, firstName middleInitial.
Answers (1)
16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.
Answers (1)
The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder
Answers (1)
Home » Engineering » Describe the anodising process, with diagrams.
Sign Up Forgot Password?