Elastic recovery: a. Is the strain that remains in a material when it is deformed plastically, then unloaded. b. Is the strain that occurs when a material is loaded elastically, then unloaded. c. Is the difference between the strain right before unloading and the strain that remains after unloading. d. None of the above.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Elastic recovery: a. Is the strain that remains in a material when it is deformed plastically, then unloaded. b. Is the strain that occurs ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
In the process of nuclear fusion, a. two or more nuclei fuse or stick together to form a heavier nucleus whose combined mass is slightly greater than the original nucleus b.
Answers (1)
Print "userNum1 is negative." if userNum1 is less than 0. End with newline. Assign userNum2 with 2 if userNum2 is greater than 10. Otherwise, print "userNum2 is less or equal 10.". End with newline.
Answers (1)
Two Technicians are discussing suspension systems. Technician A says while hitting a bump with a vehicle equipped with a solid axle front suspension both wheels would be affected.
Answers (1)
Is it common knowledge that the temperature of air rises as it is compressed. An inventor thought about using this high-temperature air to heat buildings. He used a compressor driven by an electric motor.
Answers (1)
Which statement is true? A spontaneous abortion is the same as an induced abortion. The case of Roe v. Wade legalized abortion in all three trimesters. The AMA adopted an anti-abortion position in 1959.
Answers (1)
New Questions in Engineering
Exterior wall sheathing cannot: Select one: a. provide buckling restraint for studs b. provide a nailing surface for siding c. serve as a lateral force-resisting element d. be left exposed as an exterior building surface. e.
Answers (1)
Mechatronics: Electronic Control Systems in Mechanical and Electrical Engineering: A mechatronic system contains a mechanical part and an electronic part.
Answers (2)
Technician A says centering cones are used on hub centric wheels. Technician B says centering cones are used on lug centric wheels. Who is correct? A. Technician A B. Technician B C. Both Technician A and Technician B D.
Answers (1)
Como se conecta un circuito eléctrico con dos o más resistencias en paralelo
Answers (1)
A house has a black tar, flat, horizontal roof. The lower surface of the roof is well insulated, while the upper surface is exposed to ambient air at 300K through a convective coefficient of 10 W/m2-K.
Answers (1)