Engineering

Hadassah Wu

10 June, 12:03

In order to impress your neighbors and improve your vision in traffic jams, you decide to mount a cylindrical periscope 2.0 m high and 0.1 m in diameter on top of your car. You consult the literature and find that the drag coefficient (based on frontal area) is 1.1 for Re200,000. Using this information, answer the three questions given. (HINT: make a sketch) The periscope's drag at your maximum speed of 75 mph is а bout: (A) 45 N (B) 4 N (C) 450 N (D) 5 N

+5

Answers (1)

Know the Answer?

Not Sure About the Answer?

Get an answer to your question ✅ “In order to impress your neighbors and improve your vision in traffic jams, you decide to mount a cylindrical periscope 2.0 m high and 0.1 ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.

Search for Other Answers

You Might be Interested in

Under which classification of convection would one expect the heat transfer con highest? a) - Forced b) - Mixed c) - Natural (or Free)

The concentration of carbon monoxide (co) in an exhaust gas is 1x10^4 ppmv. what is the concentration in mg/m^3 at 25 and 1 atm

A coal-fired power plant equipped with a SO2 scrubber is required to achieve an overall SO2 removal efficiency of 85%. The existing scrubber is 95% efficient.

A heat engine receives heat from a source at 1000∘C and rejects the waste heat to a sink at 50∘C. If heat is supplied to this engine at a rate of 100 kJ/s, the maximum power this heat engine can produce is (a) 25.4 kW (b) 55.4 kW (c) 74.6 kW (d) 95.

Write two scnr. nextInt statements to get input values into birthMonth and birthYear. Then write a statement to output the month, a slash, and the year. End with newline. The program will be tested with inputs 1 2000 and then with inputs 5 1950.

New Questions in Engineering

16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.

The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder

What factors are likely to promote the formation of stress corrosion cracks?

Find the mass if the force is 18 N and the acceleration is 2 m/s2

Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion