Which of the following is true about ideal standards? a. Ideal standards provide allowance for normal breakdowns and interruptions. b. Ideal standards can be achieved under efficient operating conditions. c. Ideal standards demand maximum efficiency and no slack is allowed. d. All of these choices are correct. e. None of these choices are correct.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Which of the following is true about ideal standards? a. Ideal standards provide allowance for normal breakdowns and interruptions. b. ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
A cylindrical hot water storage tank (see sketch) for a set of collectors is located in the basement of a dwelling. The tank is made of 0.080" thick steel and insulated with 3" thick fiberglass batt insulation.
Answers (1)
What is the inch equivalent of 1 millimeter
Answers (1)
A square isothermal chip is of width w = 5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at T[infinity] = 15°C.
Answers (1)
What is Potential flow?
Answers (1)
A 20 foot length of two-conductor 26 AWG copper wire is used to connect a single strain gage into a quarter-bridge circuit. If each conductor has a resistance of 20.
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)