List the four processes in the Otto cycle.

A cylindrical hot water storage tank (see sketch) for a set of collectors is located in the basement of a dwelling. The tank is made of 0.080" thick steel and insulated with 3" thick fiberglass batt insulation.

What is the inch equivalent of 1 millimeter

A square isothermal chip is of width w = 5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at T[infinity] = 15°C.

What is Potential flow?

A 20 foot length of two-conductor 26 AWG copper wire is used to connect a single strain gage into a quarter-bridge circuit. If each conductor has a resistance of 20.

Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.

The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius

Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.

What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution

The controller can be considered the brain of closed loop system