36. Technician A says that whenever drum brake shoes are being replaced, the drum brake
hardware should be cleaned in a parts washer and re-used. Technician B says that when installing
duo-servo brakes, the larger of the two shoes should be installed towards the front of the vehicle.
Who is correct?
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “36. Technician A says that whenever drum brake shoes are being replaced, the drum brake hardware should be cleaned in a parts washer and ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
What is the movement of the piston from top dead center (TDC) to bottom dead center (BDC) called?
Answers (1)
Which of the following causes an engine to run too cool? A. Blown head gasket B. Inoperative cooling fan C. Thermostat that is stuck closed D. None of the above
Answers (1)
11. Three engines operate between reservoirs separated in temperature by 300 K. The reservoir temperatures are as follows: Engine a:, Engine b:, Engine c:, Rank the engines in order of their theoretically possible efficiency, from highest to lowest.
Answers (1)
A factory has an electrical load of 1600 kW at a lagging power factor of 0.8. An additional variable power factor load is to be added to the factory. The new load will add 320 kW to the factory.
Answers (1)
What is an entrepreneur's primary responsibility?
Answers (1)
New Questions in Engineering
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
What is the main role of matrix in composites! a) - to transfer stress to the other phases b) - to protect phases from environment c) - to reduce the hardness d) - to enhance ductility
Answers (1)