What do sunspots, solar prominences, and solar flares all have in common? Group of answer choices

The composition of stainless steel is best described as an iron-carbon alloy with: Group of answer choices low carbon content, a little manganese and only residual amounts of other impurities. normally between 3.1 and 4.0 wt% carbon and some silicon.

34. What does the D stand for in the EVADE acronym?

Reaction time is how many seconds it takes the drivers vehicle to pass a target after the vehicle in front has passed it

A heat pump with refrigerant-134a as the working fluid is used to keep a space at 25°C by absorbing heat from geothermal water that enters the evaporator at 60°C at a rate of 0.415 kg/s and leaves at 40°C.

Pipe (2) is supported by a pin at bracket C and by tie rod (1). The structure supports a load P at pin B. Tie rod (1) has a diameter of 12 mm and an allowable normal stress of 110 MPa.

The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder

What factors are likely to promote the formation of stress corrosion cracks?

Find the mass if the force is 18 N and the acceleration is 2 m/s2

Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion

An open tank contains brine to a depth of 2 m and a 3-m-layer of oil on top of the brine. Density of brine is 1,030 kg/m3 and the density of oil is 880 kg/m3. What is the gage pressure (kPa) at the bottom of the tank?