Which of the following can minimize engine effort and save fuel?

A. Using cruise control

B. Driving only in low gear

C. Driving only in increments of 5 mph

D. Changing your oil once a week

A specimen of some metal having a rectangular cross section 9.61 mm x 11.5 mm is pulled in tension with a force of 8850 N, which produces only elastic deformation.

Rod is fixed at and perfectly bonded to rod at, as illustrated below. Rod has length, diameter and is made of a material with shear modulus. Rod has length, diameter and is made of a material with shear modulus.

In measuring what does NEST stand for?

What is an advantage of having two oxygen regulators on a machine-cutting torch? a. It allows the cutting pressure to be adjusted without affecting the torch flame. b. It makes it possible to change cylinders during a cut without stopping the cut. c.

A 3-phase induction motor with 6 poles is running in its normal operating range. The motor is operating at a slip of 0.1 while rotating at a speed of 1900 rpm, what is the electrical frequency used to power the motor?

16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.

The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder

What factors are likely to promote the formation of stress corrosion cracks?

Find the mass if the force is 18 N and the acceleration is 2 m/s2

Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion