Sign In
Ask Question
Engineering
Emilia Foster
21 October, 19:22
How do you find the right dynamics for a plane
+1
Answers (
1
)
Cade Proctor
21 October, 22:56
0
Airplane wings are shaped to make air move faster over the top of the wing. When air moves faster, the pressure of the air decreases. So the pressure on the top of the wing is less than the pressure on the bottom of the wing. The difference in pressure creates a force on the wing that lifts the wing up into the air.
Comment
Complaint
Link
Know the Answer?
Answer
Not Sure About the Answer?
Get an answer to your question ✅
“How do you find the right dynamics for a plane ...”
in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
3. When performing overhead work on scaffolding, what protective measures must be taken to prevent objects from falling and striking a person below? a. Fall arrest systems are used. b. Alarm systems should be enabled. c.
Answers (1)
For a 2 Vpp signal that fits within the ADC's input range, find the SQNR for: a) an 8-bit ADC with an input range of 1V to 6V b) a 9-bit ADC with an input range of 0V to 4V
Answers (1)
A tensile test is performed on a metal specimen, and it is found that a true plastic strain given is produced when a true stress of listed is applied; for the same metal, the value of K in the following equation: is 860 MPa (125,000 psi).
Answers (1)
The lower half of a 7-m-high cylindrical container is filled with water (rho = 1000 kg/m3) and the upper half with oil that has a specific gravity of 0.85. Determine the pressure difference between the top and the bottom of the cylinder.
Answers (1)
A string of ASCII characters has been converted to hexadecimal resulting in the following message: 4A EF 62 73 73 F4 E5 76 E5 Of the eight bits in each pair of digits, the leftmost bit is a parity bit.
Answers (1)
New Questions in Engineering
The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder
Answers (1)
What factors are likely to promote the formation of stress corrosion cracks?
Answers (1)
Find the mass if the force is 18 N and the acceleration is 2 m/s2
Answers (2)
Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion
Answers (1)
An open tank contains brine to a depth of 2 m and a 3-m-layer of oil on top of the brine. Density of brine is 1,030 kg/m3 and the density of oil is 880 kg/m3. What is the gage pressure (kPa) at the bottom of the tank?
Answers (1)
Home
»
Engineering
» How do you find the right dynamics for a plane
Sign In
Sign Up
Forgot Password?