Engineering

Adonis Ellison

15 January, 09:41

Under standard conditions, a given reaction is endergonic (i. e., DG >0). Which of the following can render this reaction favorable: using the product immediately in the next step, maintaining a high starting-material concentration, or keeping a high product concentration

+1

Answers (1)

Know the Answer?

Not Sure About the Answer?

Get an answer to your question ✅ “Under standard conditions, a given reaction is endergonic (i. e., DG >0). Which of the following can render this reaction favorable: using ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.

Search for Other Answers

You Might be Interested in

Describe the process that you would use to hot forge an automotive connecting rod, indicating why each of the steps is used.

What is/are the benefit (s) of short fibre reinforcements? A) Increased stiffness only. B) Increased strength and increased Toughness. C) Increased Toughness and increased flexibility. D) None of the above.

The construction time for a bridge is weather dependent. The project is expected to take 150 days if the weather is dry and hot. If the weather is damp and cool, it is expected to take 350 days. Otherwise, it is expected to take 300 days.

For laminar flow over a hot flat plate, the local heat transfer coefficient decreases with distance because (select all that are correct): A. The velocities near the plate are decreasing. B.

The two ways to solve trusses is method of sections and method of joints. a) - True b) - False

New Questions in Engineering

Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.

The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius

Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.

What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution

The controller can be considered the brain of closed loop system