Engineering

Aiden

10 July, 21:01

Derive the probability that a receptor is occupied by a ligand using a model that treats the L ligands in solution as distinguishable particles. Show that the expression is the same as obtained in the text (Equation 6.19), where the ligands were treated as indistinguishable.

+2

Answers (1)

Know the Answer?

Not Sure About the Answer?

Get an answer to your question ✅ “Derive the probability that a receptor is occupied by a ligand using a model that treats the L ligands in solution as distinguishable ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.

Search for Other Answers

You Might be Interested in

At steady state, a refrigerator whose coefficient of performance is 3 removes energy by heat transfer from a freezer compartment at 0 degrees C at the rate of 6000 kJ/hr and discharges energy by heat transfer to the surroundings, which are at 20

Many vectors are designed to double in size whenever a new element is inserted into a full vector. This operation may entail allocating a new array that is twice the size of the original, and then copying the original elements into the new array

What does the General Duty Clause require employers to do?

Electric power is to be generated by installing a hydraulic turbine-generator at a site 138 m below the free surface of a large water reservoir that can supply water at a rate of 2400 kg/s steadily. Determine the power generation potential.

Consider a variant of the thermostat of example 3.5. In this variant, there is only one temperature threshold, and to avoid chattering the thermostat simply leaves the heat on or off for at least a fixed amount of time.

New Questions in Engineering

Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.

The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius

Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.

What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution

The controller can be considered the brain of closed loop system