Ask Question
EngineeringEngineering
25 March, 16:51

The two ways to solve trusses is method of sections and method of joints. a) - True b) - False

+3
Answers (1)
  1. 25 March, 20:40
    0
    The two ways to solve trusses is method of sections and method of joints is a TRUE statement.

    Explanation:

    The method of sections consists in of an imaginary line called a section. The sum of the forces in X and Y are equal to zero. The sum of all torques is also zero. The method of joints consists of a joint isolated in which the sum of the forces in X and Y equal to zero.
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “The two ways to solve trusses is method of sections and method of joints. a) - True b) - False ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
D 4.60 A designer requires a shunt regulator of approximately 20 V. Two kinds of zener diodes are available: 6.8-V devices with rz of 10 and 5.1-V devices with rz of 25. For the two major choices possible, find the load regulation.
Answers (1)
Electric power is to be generated by installing a hydraulic turbine-generator at a site 138 m below the free surface of a large water reservoir that can supply water at a rate of 2400 kg/s steadily. Determine the power generation potential.
Answers (1)
When using a computer, you should not keep your: shoulders and upper arms in line with your torso wrists and hands straight (not bent up, down, or sideways) O feet flat on the floor or supported by a stable footrest O thighs perpendicular to the
Answers (2)
Foundation dampproofing is most commonly installed: Select one: a. on both the inside and outside of the basement wall b. Basements do not need dampproofing beyond the basement wall itself c. on the inside of the basement wall d.
Answers (1)
In Florida the fine for going over 5 mph in a school zone results in a fine of how much
Answers (2)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
Home » Engineering » The two ways to solve trusses is method of sections and method of joints. a) - True b) - False
Sign Up Forgot Password?