Ask Question
EngineeringEngineering
24 August, 23:35

Should the transmission angle for the planar four-bar linkage be close to 0? Explain?

+4
Answers (1)
  1. 25 August, 03:20
    0
    The planer four bar linkage is the type of closed chain linkage and it is also simple movable linkage system. It is also known as "four-bar" linkage.

    In this type of four bar linkage the re-volute joints are mainly designed to handle the transverse load easily as compared to load acting on the length of the link.

    The planer four bar linkage are mainly constructed when the four types of links are mainly constructed in the loop format by using the joints. These joints are basically configure so that the links can easily move in the parallel plane system.
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Should the transmission angle for the planar four-bar linkage be close to 0? Explain? ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Plot the function for. Notice that the function has two vertical asymptotes. Plot the function by dividing the domain of x into three parts: one from - 4 to near the left asymptote, one between the two asymptotes, and one from near the right
Answers (1)
In terms of the total cost ("levelized cost") per kiloWatt-hour, which of the following is the cheapest way to provide electrical energy? (a) wind power (b) geothermal power (c) solar panels on the roofs of houses (d) nuclear power
Answers (1)
when removing the pistons and rods assemblies from a cylinder block technician a positions the throw of the crankshaft at the top of its stroke and removes the connecting rod nuts and cap, tech b covers the rod bolts with protectors and pushes the
Answers (1)
Explain why the torsion test can be considered to provide a better assessment of plasticity than the tensile test.
Answers (1)
Which has greater inertia: a 1-quart milk carton filled with feathers or the same carton filled with buckshot?
Answers (1)
New Questions in Engineering
What is the definition of a fluid?
Answers (1)
You are ordering steel cable for a 250 foot long zip-line you are building in your back yard. The cable can be ordered in diameters with 1/16 inch increments. (1/16, 1/8, 3/16, 1/4, 5/16, 3/8, etc.
Answers (2)
Which of the following statements is LEAST-Likely true? A) Do not attempt to unseat the beads of an inflated tire. B) Do not strike the tire or rim with a hammer. C) A hammer is sometimes necessary when removing a passenger car tire.
Answers (1)
What is the pitch circle diameter of a 50-tooth spur gear having a circular pitch of 0.375 inch
Answers (1)
Emergency plans are being formulated so that rapid action can be taken in the event of an equipment failure. It is predicted that if a particular pipeline were to rupture, it would release ammonia at a rate of 100 lb/s.
Answers (1)
Home » Engineering » Should the transmission angle for the planar four-bar linkage be close to 0? Explain?
Sign Up Forgot Password?